Precautions for use of centrifugal sedimentation machine

The centrifugal precipitator used in the laboratory is very fast. Therefore, everyone must pay attention to safety when using it, and put their safety first. When using the centrifugal sedimentation machine, it is also necessary to prevent the equipment from moving during the work due to aging, imbalance, etc., resulting in a dangerous accident. After the centrifuge tube is broken, its glass fragments will fly out, which will hurt everyone's safety. Therefore, when we use the centrifugal sedimentation machine, we must pay attention to the following operations, and it is very good to prevent it before it happens. necessary.

1. All the sleeves of the centrifugal sedimentation machine should be protected by soft things under the bottom and bottom, such as test tube pads or cotton.

2. When you start the machine, you should cover the top cover and you can start it. When the body of the centrifugal sedimentation machine vibrates, or when some noise is emitted, it is necessary to immediately cut off the power and start to check the route of the fault to ensure safety.

3, the centrifuge tube must be placed symmetrically into the machine equipment, this can also prevent the vibration of the fuselage due to instability during the use of the process, if there is only one sample of the test tube, you need to put In another test tube, put the same amount of water instead.

4. When you are at the end of the use, you must first turn off the centrifugal sedimentation machine, and then cut off the power supply. Be sure to open the cover of the device after the rotation of the machine has stopped, and take out the sample. Never use external force to stop it. Rotating, this will also allow everyone's safety to be further protected.

5. After closing the door of the centrifugal sedimentation machine, be sure to set the settings of each item clearly on the instrument panel, for example: 7000 rpm, 25 min. These must be set up, and must be careful not to allow the speed to exceed the limits of its centrifugal sedimentation machine. If your machine is a bit old, you can only adjust the power down. The speed and time must not be adjusted too high, otherwise it will cause a dangerous accident.

I hope that the above can help everyone, so that everyone pays more attention to safety during the use process. If you want to know more about the centrifugal sedimentation machine, you can come to our official website for online consultation. I believe you will get a satisfactory reply.